Simple Water Level Indicator

 

Description

This is the circuit diagram of a simple corrosion free water level indicator for home and industries.In fact the the level of any conductive non corrosive liquids can be measured using this circuit.The circuit is based on 5 transistor switches.Each transistor is switched on to drive the corresponding LED , when its base is supplied with current through the water through the electrode probes.

One electrode probe is (F) with 6V AC is placed at the bottom of tank.Next probes are placed step by step above the bottom probe. When water is rising the the base of each transistor gets electrical connection to 6V AC through water and the corresponding probe.Which in turn makes the transistors conduct to glow LED and indicate the level of water.The ends of probes are connected to corresponding points in the circuit as shown in circuit diagram.Insulated Aluminum wires with end insulation removed will do for the probe.Arrange the probes in order on a PVC pipe according to the depth and immerse it in the tank.AC voltage is use to prevent electrolysis at the probes.So this setup will last really long.I guarantee at least a 2 years of maintenance free operation.That’s what I got and is still going.

Components

T1 – T5 BC 548 or 2N2222 Transistors

R1-R5 2.2K 1/4 W Resistors

R6-R10 22K 1/4 W Resistors

D1 – D5 LED’s ( color your choice)

Notes

Use a transformer with 6V 500 mA output for power supply.Do not use a rectifier! we need pure AC. Use good quality insulated Aluminum wire for probes.If Aluminum wires are not available try Steel or Tin.Copper is the worst.Try the circuit first on a bread board and if not working properly, make adjustments with the resistance values .This is often needed because conductivity of water changes slightly from place to place.